Product Overview Enhanced tile adhesive can be pasted low water absorption and has a wide seam outside wall. Scope * ordinary tiles, especially outside the wall, terracotta tiles and various types of slate, marble and other natural stone; * indoor and outdoor cement mortar, concrete or masonry base. * Brick renovation features with anti-fall performance advantages *; * No dip brick, quick construction;. * Thin construction, reduce weight; * weather, water resistance; * strong bond, easy hollowing; * nontoxic. Surface treatment * All surfaces should be solid, clean, without hollowing, no oil, wax stains, mold release agents and other loose material; * painted surface should be rough cut, exposing at least 80% of the original surface; * completed concrete surface After curing should be at least 28 days before tiling; * new plaster surface should be at least seven days before curing paving; * the old concrete and plaster surfaces can use industrial detergent or degreaser to clean, then rinse with water cannons . Its surface is dry before tiling after 24 hours; * remove the concrete surface residues, particularly on sloping concrete slab of the residual release agent; * in water absorption substrates or at high temperatures, dry conditions, Before construction must first wetting the base surface. Mixing: * the powder into the water and stir into a paste, attention first and then pour the powder with water, using an electric mixer, while stirring, if the weight is less than 5kg, can use artificial mixing; * mixing ratio of powder 20 kg: 5 liters of water; * gouache adequate mixing, whichever is completely raw dough, stir slightly to place finish still need about ten minutes after mixing before use, to increase adhesion. Construction Technology: Paving tiles using tile adhesive, you can use traditional point paste method, is about mixing good glue applied to the back of the tile, and then paste it on top of the substrate. However, this is likely to cause the hollowing paste method, so we strongly recommend using a squeegee method, as follows: * Use tooth scraper will glue applied over the face, so that a uniform distribution, and the formation of a section of the dentate . Each about one square meter coating (depending on the weather temperature) and then in the open time rubbing pressure on the tile can be; * Choose tooth scraper should consider the size bump on the back of the flatness and tile Face degree; * as deep fissure on the back of the tile or stone, tile larger and heavier, you should double-sided adhesive, namely in the back while working surface coated with mortar and tile. About indoor stone facade without nails without nail paste 1. paste generally applies to an area equal to or less than 400mm × 400mm, 20mm thickness equal to or less than the stone; if the stone below 18mm thickness, the area may be amplified accordingly; 2. Size and thickness exceeds the stone, or quality, specific weight of the stone, you need to do first scene paste trials to determine whether it is appropriate to take no nails Paste.